1988 Rover 820e – J.C-T.
1988 Rover 820e – James Copp-Taylor
Back in 1999, I had just written off my 1988 820Si. I was offered a Lynx Bronze 820e for 400 pounds. One quick trip to the bank and 400 pounds later, I am the ‘proud’ owner of a slightly down at heel 1988 Rover 820e. The VIN number suggested that this was a later car than my 820Si, which meant a later style centre console and less rust potential. It was also a second generation 820e, which meant no electric mirrors, the really cheaped out door cards and barely any wood trim. First order of business was to raid the wood trim from my 820Si. This went in reasonably well and lifted the interior a touch.
Next voyage of discovery was realising just how tired the engine was. At 115,000 miles it was burning through a litre of oil every few hundred miles and producing a visible haze of blue smoke. The lead me on to discover just how underdeveloped the SPFi engine management system actually was. The whole setup had been developed to provide Ignition control (with knock sensor) and a single point injection multi nozzle injector setup which relied on all the usual inputs of an MPFi setup, such as coolant temperature, throttle position, crank position, and manifold absolute pressure. However, it was not fully developed. Every battery disconnection would result in an expensive trip to a local ARG dealer…who would then duly hook up two different fastcheck modules, one to calibrate the base CO and another to, if I recall, setup the mixture. This level of hassle was never an issue with the Lucas Hotwires multi-point setup.
All of these delights were discovered after much research, after the fact. For me, it resulted in over fuelling, bore wear and the need replace the entire engine, not once…..but twice. My second unit used 5 litres of oil every 60 miles and left some, quite frankly, impressive smoke clouds on the over run. The third engine came from a dealer serviced but crash damaged example, which had a far more acceptable 1000 miles and 1litre oil consumption habit.
Once the engine was sorted, my attention turned to the bodywork. I fitted four rust free doors, taken from a later ‘4 dial’ 820 Si and proceeded to have them sprayed the correct Lynx bronze.
Next, the running issues. At part throttle the engine would stutter, once warm…..it would run…terribly. I replaced the coolant sensor, and all was well once more….but after a month, the stutter was back. After some investigation with the multi meter, I found that the three pin plug connecting to the throttle position sensor had a pin that was only just making a connection. I visited the local scrapyard, cut the length of loom I needed, including the plug….and then soldered the replacement onto my existing loom.
The end result was never having the problem again. I carried out basic servicing after that…..oil,filter, coolant….and drove the car for a reliable 30,000 miles before getting my first 2.7. In the end, the SPFi setup proved to be mostly reliable but very maintenance prone. Rover duly took note and used this Motorola built setup as the basis for the MEMS engine management solution that proved to be far more reliable. However, it was down to the owners of these early SPFi setups to do much of the development!!. Premature engine wear, for example………inability for the system to operate long term in a non-calibrated state…even if you did do the ‘budget base CO setup’ as outlined in the Haynes and Owners manuals. The get out clause was always ‘visit the main dealer ASAP’, but….when you’ve got a third hand car which at the time, actually had NEGATIVE scrap value….who was going to actually bother?
In the end, I enjoyed my 820e and built up a real bond with it. I learnt a lot, and this set me in good stead to be able to further broaden my mechanical experience and knowledge!.
Using any technical methods and advice provided on our website is at your own risk. The Rover 600 & 800 Owners Club is not responsible for any issues arising from the advice given.
